The programming sequence follows the pattern:
Program address
- [PROG] [1-3 digit address] [ENTER]
- 1 short beep if OK, 1 long beep if error, THEN
Sub-address
- [PROG] [1-3 digit address]
- 3 short beeps if OK, 1 long beep if error
Default Installer Code => 000000
Default Master Code => 123
Changing an Installer Code
This code is used to enter the full Installer Program mode (Program LED flashing on LED Keypad). The default installer code is 000000. This code can only be changed while in Installer Program Mode. To enter your new installer code press P25E1E. The existing code will be displayed at the keypad (either each digit flashed out sequentially on an LED keypad or shown on the bottom line of the LCD keypad). To change the code simply enter the digits of the new code and it will replace the old one. The Installer Code must be between 4-6 digits in length.
Adding or changing a User Code
Up to 100 codes can be programmed into the panel. The user codes are located in address P1E 1-100E. By default, Code 1 has Master Code permissions and must be used to enter the Client program mode. Codes 1-100 may be varied in length from 1 to 6 digits (unless option 8 at P25E11E is on then the codes must be between 4-6 digits long).
Example: program User 2 to 2580
P1E2E 2580E
3 beeps – program light on solide or flashing